I cannot get further than GRUB except to rescue mode, when I attempt to boot the main Fedora OS it gets stuck on searching for a disk indefinitely. Gets stuck on Job dev-disk-by\<many symbols>.device/start running (1h / no limit) in the console.

I have a Windows partition on same drive, it also doesn’t boot, it’s rescue command prompt (from where you are instructed to open notepad to rescue files) doesn’t “see” any disk but C: and X: (emerg boot).

I tried booting this machine with two live OS USBs: Fedora and SystemRescue. Neither of them list the SSD (or anything but the USB drive FS itself) in lsblk or the file manager.

Due to lack of storage mediums, I haven’t done a backup in a while. How can I rescue the files? Many passwords are also stuck there, in Firefox manager I wasn’t able to sync due to losing access to the 2FA email.

Edit: SOLVED! Needed to switch disk mode in BIOS/UEFI from RAID to AHCI. IDK how it got to RAID in the first place.

  • Pumpkin Escobar@lemmy.worldEnglish
    1·
    24 hours ago

    It does look like your storage controller got switched to raid mode. Some ai generated slop-fix:

    Your storage controller actually is visible in the lspci output, but it is currently hidden inside a RAID cluster.

    Look closely at this specific line from your list:
    00:17.0 RAID bus controller: Intel Corporation Comet Lake PCH-H RAID

    Why Your Drive Seems Missing

    • Intel RST Active: Your motherboard BIOS is configured to use Intel Rapid Storage Technology (RST) RAID mode.
    • Controller Hiding: When RAID mode is active, the Intel controller intercepts individual NVMe or SATA drives.
    • Linux Limitation: The standard Linux kernel cannot see individual NVMe drives behind this specific Intel RAID controller without configuration.

    How to Fix It

    You need to switch your storage controller from RAID mode to AHCI/NVMe mode.

    1. Reboot your laptop and enter the BIOS setup (usually by pressing F2, F12, or Del at startup).
    2. Locate the Storage Configuration, SATA Mode, or VMD Setup menu.
    3. Change the setting from RAID or Intel RST to AHCI (or disable VMD).
    4. Save and exit. [1]

    **